Now, you should see the received image on the GUI. Select the image that you want to process and transmit then click 'Start'. Click the 'LabVIEW' button on the top-right corner so it turns to green. You can set Auto Gain levels in 10% increments or turn Auto Gain off. It will open up the CAE compressor or CNN denoiser GUI based on your selection. Goniometer button: Switch the main display to the Goniometer.Īuto Gain knob and field: Set the amount of display compensation for low input levels. The signal trace slowly fades to black, imitating the retro glow of the tubes found in older goniometers, while also enhancing the readability of the display.įor information about adding the MultiMeter effect to a clip and showing the effect’s controls, see Add Logic effects to clips in Final Cut Pro. To use such devices as goniometers, users would connect the left and the right stereo channels to the X and Y inputs, while rotating the display by 45° to produce a useful visualization of the signal stereo phase. The idea of the goniometer was born with the advent of early two-channel oscilloscopes. Phase problems are easily spotted as trace cancelations along the center line, labeled M for mid/mono. The MultiMeter effect’s Goniometer helps you judge the coherence of the stereo image and determine phase differences between the left and right channels. MultiMeter Goniometer controls in Final Cut Pro Logic effects included with Final Cut Pro.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |